|
|
|
#1
04-13-2011, 08:22 PM
|
|||
|
|||
Hey
Hello from South Carolina.
Finally getting a chance to post an intro and make everything official. I have been playing with metal at work and at home for quite a while. I grew up building cars, planes and fixing the farm equipment. Now I work as an engineer designing and developing roller bearings. I am here to learn metal forming techniques & tricks and share some of my own. Currently I am without a major project so I spend most of my shop time practicing techniques or building new tools. Thanks Justin
__________________
Justin 
|
|
#3
04-14-2011, 01:19 AM
|
|||
|
|||
|
Thats the way to learn! Welcome to the site Justin.
David
__________________
Metalshaping DVD. www.metalshapingzone.com Metalshaping with hand tools on youtube http://www.youtube.com/watch?v=IGElSHzm0q8 All things are possible.
|
|
#4
04-14-2011, 05:46 PM
|
|||
|
|||
|
Hi Justin
Welcome to the site. I am near Aiken; where abouts are you located? I am resto-modding a 1973 Mazda RX2 and building a shop at the same time
__________________
John Vintage Rotary Nut 
|
|
#5
04-16-2011, 06:41 AM
|
|||
|
|||
|
Thanks to all for the welcome.
I am on the south side of Greenville. Good luck with both builds. I have been drooling over the 12-gauge shop over at garagejournal.com and grabbing ideas. Check it out if you haven't seen it already... http://www.garagejournal.com/forum/showthread.php?t=55006
__________________
Justin
|
 |
|
|
Linear Mode
