Hey
 

Hello from South Carolina.

Finally getting a chance to post an intro and make everything official.

I have been playing with metal at work and at home for quite a while. I grew up building cars, planes and fixing the farm equipment. Now I work as an engineer designing and developing roller bearings.

I am here to learn metal forming techniques & tricks and share some of my own.

Currently I am without a major project so I spend most of my shop time practicing techniques or building new tools.

Thanks
Justin

Welcome Justin!

Thats the way to learn! Welcome to the site Justin.

David

Hi Justin
Welcome to the site. I am near Aiken; where abouts are you located?

I am resto-modding a 1973 Mazda RX2 and building a shop at the same time

Thanks to all for the welcome.

I am on the south side of Greenville. Good luck with both builds. I have been drooling over the 12-gauge shop over at garagejournal.com and grabbing ideas. Check it out if you haven't seen it already...

http://www.garagejournal.com/forum/showthread.php?t=55006