|
|
|
#1
10-14-2013, 06:17 AM
|
|||
|
|||
Greetings from Queensland
My name is Peter and I'm located in Sharon (near Bundaberg) in Queensland, Australia. I'm a Boilermaker/ Sheet metal worker by trade but now work in Agriculture.
I've had a soft spot for 60's/70's Italian cars since I was a teenager, always having quite a few at any one time. So needless to say I've always had bodywork to do on them. I've known about metal shaping but until a few years ago thought it was a bit of a secret art and never realised there were people out there prepared to share their skills and knowledge. So I'm very excited to have found this forum and can't believe how helpful and friendly everyone is, from beginner through to expert. Looking forward to learning!
__________________
Peter Peterson 
|
|
#2
10-14-2013, 02:19 PM
|
|||
|
|||
|
Hi Peter welcome to the forum.
David
__________________
Metalshaping DVD. www.metalshapingzone.com Metalshaping with hand tools on youtube http://www.youtube.com/watch?v=IGElSHzm0q8 All things are possible.
|
|
#4
10-14-2013, 06:24 PM
|
|||
|
|||
|
Hi Peter welcome to the forum
Peter PS Nice nane 
__________________
P.Tommasini Metalshaping tools and dvds www.handbuilt.net.au Metalshaping clip on youtube http://www.youtube.com/watch?v=WEAh91hodPg Making Monaro Quarter panel: http://www.youtube.com/watch?v=KIpOhz0uGRM
|
|
#5
10-16-2013, 12:16 AM
|
|||
|
|||
|
Hi Peter, Welcome!
__________________
Steve ærugo nunquam dormit
|
 |
|
|
Linear Mode
