|
|
|
#1
07-21-2013, 05:10 PM
|
|||
|
|||
Greetings from Malaysia..
Hello All... i am from Kuala Lumpur, Malaysia..and have been loving this form of
arts for so many years. Am a complete newbie (dont even own most of the common basic tools to jump start properly..other than a sheet and a hammer).. and lotsa stuff to learn. Hopping to gain experience in obtaning the best tools for a beginner and some applied knowledge from the best around here.. Enjoy and be safe
__________________
Irwin 
|
|
#2
07-22-2013, 05:06 AM
|
||||
|
||||
|
Irwin, welcome and thanks for the introduction. Hope you enjoy the site and find it helpful. Thanks for joining us. If you have a question just ask and someone will try to help you.
__________________
Joe Hartson There is more than one way to go to town and they are all correct.
|
|
#3
07-22-2013, 06:47 AM
|
|||
|
|||
|
HI Irwin welcome to the forum
as Joe said all you need.... it's just ask Peter
__________________
P.Tommasini Metalshaping tools and dvds www.handbuilt.net.au Metalshaping clip on youtube http://www.youtube.com/watch?v=WEAh91hodPg Making Monaro Quarter panel: http://www.youtube.com/watch?v=KIpOhz0uGRM Last edited by Peter Tommasini; 07-22-2013 at 06:49 AM.
|
|
#5
07-22-2013, 12:38 PM
|
|||
|
|||
|
Hello Irwin, you don't need a lot of tools to do most things a lot can be achieved with just a few hand tools. Machines just make things quicker.
David
__________________
Metalshaping DVD. www.metalshapingzone.com Metalshaping with hand tools on youtube http://www.youtube.com/watch?v=IGElSHzm0q8 All things are possible.
|
 |
|
|
Linear Mode
