|
|
|
#1
07-19-2013, 10:22 AM
|
|||
|
|||
new member Florida
hi, I met Kerry at a GMC motorhome rally and attended his sermon on metalshaping. I'm now a disciple.
I'm building a replica of a Morgan 3 wheel car. see: www.jzrusa2.blogspot.com at some point I'd like to replace the fiberglass with alum. as I enjoy all types of metal work. Fred V
__________________
Fred V 
|
|
#2
07-19-2013, 12:00 PM
|
||||
|
||||
|
Fred, welcome and thanks for the introduction. Hope you enjoy the site and find it helpful. Thanks for joining us. Sounds like you have an interesting project with the Morgan 3 wheeler. If you get to the Mississippi Gulf Coast look me up, I give you a quick tour of my shop.
__________________
Joe Hartson There is more than one way to go to town and they are all correct.
|
|
#3
07-19-2013, 12:19 PM
|
|||
|
|||
|
Hello Fred, welcome to the forum.
David
__________________
Metalshaping DVD. www.metalshapingzone.com Metalshaping with hand tools on youtube http://www.youtube.com/watch?v=IGElSHzm0q8 All things are possible.
|
|
#5
07-19-2013, 04:48 PM
|
|||
|
|||
|
thanks for the welcome. I've messed a bit with sheet metal shaping as shown on the attachment but I had problems with it. I hope to learn some tricks here. The pic is the end panel of a water tank for one of my steam engines.
Fred v brass end.jpg tank solder.jpg
__________________
Fred V Last edited by Steve Hamilton; 07-19-2013 at 04:57 PM.
|
|
#6
07-20-2013, 01:33 AM
|
|||
|
|||
|
HI Fred welcome to the forum
Peter
__________________
P.Tommasini Metalshaping tools and dvds www.handbuilt.net.au Metalshaping clip on youtube http://www.youtube.com/watch?v=WEAh91hodPg Making Monaro Quarter panel: http://www.youtube.com/watch?v=KIpOhz0uGRM
|
|
#7
07-20-2013, 05:32 AM
|
||||
|
||||
|
steam engine? brass? morgan 3?!?! This guy is cool!
I am following your blog now! pretty cool project
__________________
Brent Click
|
 |
|
|
Linear Mode
