|
|
|
#1
03-23-2022, 02:47 PM
|
|||
|
|||
New member and new to metal shaping
Hello,
My name is Jimmy Angelo and I am looking to get into metal shaping. I currently live in Hudson, WI (about 30 mins from Minnapolis, MN). I am currently working on building a hot rod that will require some metal work and repair. Once that project is complete I would to build an old school Harley chopper. I have no metal shaping tools, but do have an oxy/act. torch set and an older MillerMatic 200. I may sell the welder and purchase the newer MillerMatic 211 as I do not have 220V in my garage at this time. Looking forward to learning from the group. 
|
|
#2
03-26-2022, 11:53 AM
|
|||
|
|||
|
Welcome!
This is graygeezer on instagram or just Jeff in everyday life. Here's a link to events in area I've gone to before and enjoyed, hopefully they are back post COVID. https://www.allmetalshaping.com/foru...er=desc&page=2 Metalshaping the northwoods is in the Cumberland WI area. Minnesota metalshaping is near Dennison MN.
__________________
Jeff
|
 |
|
|
Linear Mode
