|
|
|
#1
03-13-2016, 05:12 PM
|
|||
|
|||
New member from nova Scotia
Hi, Matt from nova Scotia. Started building an English wheel. Looking for some tips and tricks on metal shaping. Instead of just beating it into submission.
Thanks for your great site. Matt Last edited by Matt1376; 03-13-2016 at 08:43 PM. 
|
|
#2
03-13-2016, 11:39 PM
|
||||
|
||||
|
Hello Matt and welcome to the site.
Jere
__________________
Jere Kirkpatrick Valley Forge & Welding HEN-ROB Torch Dealer.  Teaching The Fundamentals of Metal Shaping www.jerekirkpatrick.com All tools are a hammer except the chisel.....That's a screwdriver.
|
|
#3
03-14-2016, 05:42 AM
|
||||
|
||||
|
Hi Matt, my dad was from Truro but grew up in Sackville. Welcome to the site...GM
|
|
#4
03-14-2016, 07:10 AM
|
|||
|
|||
|
Hi Matt welcome to the forum
Peter
__________________
P.Tommasini Metalshaping tools and dvds www.handbuilt.net.au Metalshaping clip on youtube http://www.youtube.com/watch?v=WEAh91hodPg Making Monaro Quarter panel: http://www.youtube.com/watch?v=KIpOhz0uGRM
|
 |
|
|
Linear Mode
