|
|
|
#1
04-27-2014, 11:42 PM
|
|||
|
|||
Introduction
Hi all,
My name is Scott and I am one of the two owners of Wicked Customs Langley. By trade I am an aircraft structural tech and maintenance engineer. for the last 15 yrs I have been a professional Firefighter and the owner of a hot rod shop called Wicked Customs. I was born and raised with hot rods and was lucky enough to have been brought up around some of the pacific northwest's hot rod legends. Working in the aircraft industry aloowed me to gain knowledge of sheet metal fabrication however there is a great deal more to learn when it comes to pannel beating and complex shaping. I look forward to learnig all I can from being involved in this forum and hope that I can share any experience that I have. Cheers
__________________
Scott 
|
|
#3
04-28-2014, 08:44 AM
|
|||
|
|||
|
Welcome to the forum Scott.
David
__________________
Metalshaping DVD. www.metalshapingzone.com Metalshaping with hand tools on youtube http://www.youtube.com/watch?v=IGElSHzm0q8 All things are possible.
|
|
#5
04-28-2014, 03:02 PM
|
|||
|
|||
|
Hi Scott welcome to the forum
Peter
__________________
P.Tommasini Metalshaping tools and dvds www.handbuilt.net.au Metalshaping clip on youtube http://www.youtube.com/watch?v=WEAh91hodPg Making Monaro Quarter panel: http://www.youtube.com/watch?v=KIpOhz0uGRM
|
|
#6
04-29-2014, 10:14 AM
|
||||
|
||||
|
Hello Scott welcome to the site.
Jere
__________________
Jere Kirkpatrick Valley Forge & Welding HEN-ROB Torch Dealer.  Teaching The Fundamentals of Metal Shaping www.jerekirkpatrick.com All tools are a hammer except the chisel.....That's a screwdriver.
|
 |
|
|
Linear Mode
