|
|
|
#1
04-01-2014, 06:02 PM
|
|||
|
|||
looking to learn
Hello , My name is Steve D and I reside in Merrimack N.H. I recently retired from a heavy truck dealership after 46 years working in the parts dept. My present challenge is to repair and rebuild a 51 Chevy Bel Air and thus I hope to learn about metal shaping . I'm hoping to do so repairing metal rather than filling with plastic filler.
__________________
Steve D 
|
|
#3
04-01-2014, 07:08 PM
|
|||
|
|||
|
Hi Steve welcome to the forum
Peter
__________________
P.Tommasini Metalshaping tools and dvds www.handbuilt.net.au Metalshaping clip on youtube http://www.youtube.com/watch?v=WEAh91hodPg Making Monaro Quarter panel: http://www.youtube.com/watch?v=KIpOhz0uGRM
|
|
#4
04-01-2014, 07:29 PM
|
||||
|
||||
|
Hello Steve and welcome.
Very little filler used on this site. Jere
__________________
Jere Kirkpatrick Valley Forge & Welding HEN-ROB Torch Dealer.  Teaching The Fundamentals of Metal Shaping www.jerekirkpatrick.com All tools are a hammer except the chisel.....That's a screwdriver.
|
 |
|
|
Linear Mode
