|
|
|
|
|
#1
10-11-2013, 12:19 PM
|
|||
|
|||
Hello Bob,
welcome to the forum. Sounds like you have a good few machines so you must be pretty into this stuff already. Knowing where to put the welded joints and techniques to keep distortion to a minimum are something I consider key to getting good results in the finished panels. Have a look around the site and ask questions if you have any, there is always someone who will have an answer. David
__________________
Metalshaping DVD. www.metalshapingzone.com Metalshaping with hand tools on youtube http://www.youtube.com/watch?v=IGElSHzm0q8 All things are possible. 
|
 |
|
|
Hybrid Mode
