|
|
|
#1
03-12-2013, 08:10 PM
|
|||
|
|||
From sunny and HOT Phoenix AZ
Hello all! My name is Mike Proulx, have been a welder/fabricator for 30 years and new to metal shaping. I have a need for some sheet metal parts for my motorcycle so I watched Lazze metal shaping videos and got hooked. I am in the process of buying an English wheel, bead roller, shrink-er and stretcher. I know I will cull an enormous amount of knowledge, and maybe a friend or two. I am ready to have fun!
__________________
Mike 
|
|
#2
03-13-2013, 12:47 AM
|
||||
|
||||
|
Mike, welcome and thanks for the introduction. Hope you enjoy the site and find it helpful. Thanks for joining us.
__________________
Joe Hartson There is more than one way to go to town and they are all correct.
|
|
#4
03-13-2013, 10:21 PM
|
|||
|
|||
|
HI Mike welcome to the forum
Peter
__________________
P.Tommasini Metalshaping tools and dvds www.handbuilt.net.au Metalshaping clip on youtube http://www.youtube.com/watch?v=WEAh91hodPg Making Monaro Quarter panel: http://www.youtube.com/watch?v=KIpOhz0uGRM
|
|
#5
03-13-2013, 10:55 PM
|
|||
|
|||
|
barry larson
Mike You need to get hold of the guy that just poasted as Terry.....He just put together a small power hamer and has a bead roller about ready to run..Also in Mesa.....I am hear for a couple more weeks then back to Mn....Good luck and have fun. Barry Larson Mesa Anoka MN.........
__________________
Barry Larson
|
|
#6
03-14-2013, 09:38 AM
|
||||
|
||||
|
Welcome Mike. I'm from Phoenix too. I have a few tools you could use if needed
__________________
Rick
|
|
#8
03-14-2013, 04:48 PM
|
||||
|
||||
|
There's a few of us here in the PHX metro area.
I should probably be thinking of a meet and greet sometime. 
|
|
#10
03-14-2013, 07:16 PM
|
||||
|
||||
|
Good idea Steve. We all wanna come drool over your new pullmax.
__________________
Rick
|
 |
|
|
Linear Mode
