|
|
|
#1
11-06-2012, 03:56 PM
|
|||
|
|||
Newb from Tennesee
Hello. I'm an old car fixer upper but I got out of it when I had kids. They are grown now and I'm getting back in old cars but I now have the displeasure of fixing rust damage. I've recently purchased some econo stuff to get started. A Hobart 140 MIG, a Woodward bead roller, Woodward stretcher/shrinker, 5" metal shear and some other stuff.
Well I've already run into the issues with the off shore bead roller and was refered to this site for some ideas. Project number one is making lower quarter patch panels for my 1970 Maverick. David 
|
|
#2
11-06-2012, 04:44 PM
|
||||
|
||||
|
David, welcome and thanks for the introduction. Hope you enjoy the site and find it helpful. Thanks for joining us.
__________________
Joe Hartson There is more than one way to go to town and they are all correct.
|
|
#4
11-06-2012, 11:38 PM
|
|||
|
|||
|
HI Dave welcome to the forum
Peter
__________________
P.Tommasini Metalshaping tools and dvds www.handbuilt.net.au Metalshaping clip on youtube http://www.youtube.com/watch?v=WEAh91hodPg Making Monaro Quarter panel: http://www.youtube.com/watch?v=KIpOhz0uGRM
|
 |
|
|
Linear Mode
