|
|
|
#1
08-28-2012, 11:16 AM
|
|||
|
|||
Hi Everyone, new meber from The Netherlands
I am interested in all kinds of metalworking. Am currently restoring a 1954 Chevrolet Paneltruck and a 1954 Cabover Engine. Allready have a 1954 pickup that is finished, so will be a nice set of 3 1954 Chevy trucks when all finished. I'm looking for plans to build an english wheel, still not sure which design is best. Allready have the upper and lower wheels for it. Hope to find some interesting information here on this website.
__________________
Rob Debije 
|
|
#2
08-28-2012, 11:41 AM
|
||||
|
||||
|
Hi Rob and welcome!
 I built a lower adjuster and an upper adjuster English wheel. I like the upper better. It is an Imperial clone.
__________________
Rick Scott The second mouse gets the cheese!
|
|
#4
08-28-2012, 05:16 PM
|
|||
|
|||
|
Hi Rob and welcome to allmetalshaping!.
David
__________________
Metalshaping DVD. www.metalshapingzone.com Metalshaping with hand tools on youtube http://www.youtube.com/watch?v=IGElSHzm0q8 All things are possible.
|
|
#5
08-29-2012, 03:40 AM
|
|||
|
|||
|
HI Rob welcome to the forum
Peter
__________________
P.Tommasini Metalshaping tools and dvds www.handbuilt.net.au Metalshaping clip on youtube http://www.youtube.com/watch?v=WEAh91hodPg Making Monaro Quarter panel: http://www.youtube.com/watch?v=KIpOhz0uGRM
|
|
#6
08-30-2012, 04:30 PM
|
|||
|
|||
|
Hi Rick, I looked at the Imperial English wheel and was thinking about building an Imperial clone. Now that you say you prefer this one to the other one you have built I will definately build an Imperial clone. thanks for the reply.
Jeroen, I will try to upload some pictures of my Chevy trucks here.
__________________
Rob Debije
|
 |
|
|
Linear Mode
