|
|
|
#1
11-04-2011, 11:46 AM
|
|||
|
|||
Hi everyone!
Nice to meet you all,
My name is Vincent Beckers, I'm 15 years old and I live in belgium (Flanders). I recently bought my first car (a VW t2b from 1978) and I'm restoring it. I enjoyed making some small parts for the body, but I'm always hungry for more information, tips and techniques to make more complicated parts. After a few weeks of watching youtube videos about bodywork and panelbeating I bumped into this forum and I hope to learn alot here (but I think that will not be a problem here   ).Hope you know me a little bit now  !
__________________
Greetings from Belgium, Vincent Beckers 
|
|
#2
11-04-2011, 08:53 PM
|
||||
|
||||
|
Vincent, welcome and thanks for the introduction. There is a lot of information here that will help you learn how to shape sheet metal. If you have a question ask and someone will try to help you. Thanks for joining us.
__________________
Joe Hartson There is more than one way to go to town and they are all correct.
|
|
#5
11-05-2011, 05:50 PM
|
|||
|
|||
|
Welcome to the site Vincent good to se someone starting at your age!
keep it going you whan 't be sorry  Peter
__________________
P.Tommasini Metalshaping tools and dvds www.handbuilt.net.au Metalshaping clip on youtube http://www.youtube.com/watch?v=WEAh91hodPg Making Monaro Quarter panel: http://www.youtube.com/watch?v=KIpOhz0uGRM
|
|
#7
11-06-2011, 04:39 PM
|
|||
|
|||
|
Hello Vincent, welcome to the site, Its nice to see young people learning hand skills.
David
__________________
Metalshaping DVD. www.metalshapingzone.com Metalshaping with hand tools on youtube http://www.youtube.com/watch?v=IGElSHzm0q8 All things are possible.
|
 |
|
|
Linear Mode
