|
|
|
#1
02-19-2011, 09:53 PM
|
|||
|
|||
Defender Chassis is in the house
Team,
I was referred to this site by someone on garage journal. While here I hope to pick up some metal shaping talents that I have yet to fully develop. I hope that I will also be able to pass along some knowledge at the same time. I am an engineer by trade and am lucky enough to make a nice living doing so. I have a side business call Defender Chassis, hence the screen name. Defender Chassis does work on race cars, mostly drag cars. I am lucky to have been able to acquire what I consider a nicely tooled shop for the type of work my business does. My hope is to someday build a 245" dragster from the ground up and set a personal record of 200mph in the 1/4 mile. Not sure what else to add except if you need something don't be afraid to ask.
__________________
Scott 
|
|
#2
02-19-2011, 10:15 PM
|
||||
|
||||
|
Scott, welcome to the site and thanks for the introduction. I lived in Ravenswood for 13 years. Hope the site fits your needs. Thanks for joining us.
__________________
Joe Hartson There is more than one way to go to town and they are all correct.
|
|
#3
02-19-2011, 10:39 PM
|
|||
|
|||
|
Joe,
Thanks for the welcome. Did you work for the aluminum plant in Ravenswood?
__________________
Scott
|
|
#4
02-19-2011, 10:43 PM
|
||||
|
||||
|
That is where I worked. Also did a lot of racing with Hemmy Adkins with the AMX. Do you know him?
__________________
Joe Hartson There is more than one way to go to town and they are all correct.
|
|
#6
02-19-2011, 10:58 PM
|
|||
|
|||
|
Quote:
__________________
Scott
|
 |
|
|
Linear Mode
