|
|
|
#1
03-14-2016, 09:52 AM
|
|||
|
|||
Hello
Hello gentlemen, I'm Stephen and I'm from Richmond Virginia. I'm new new to metal shaping and joined in an attempt to understand the art of shrinking and stretching metal. (I admit the shrinking part baffles my mind.) My original intent is to repair some body panels on an 1981 Chevy pickup, but after seeing some of the projects here, maybe, just maybe I could aim higher in my own aspirations.
Stephen
__________________
Stephen 
|
|
#2
03-14-2016, 05:43 PM
|
|||
|
|||
|
Hi Stephen welcome to the forum
Peter
__________________
P.Tommasini Metalshaping tools and dvds www.handbuilt.net.au Metalshaping clip on youtube http://www.youtube.com/watch?v=WEAh91hodPg Making Monaro Quarter panel: http://www.youtube.com/watch?v=KIpOhz0uGRM
|
|
#3
03-15-2016, 12:07 PM
|
||||
|
||||
|
Hello Stephen and welcome to the site.
Jere
__________________
Jere Kirkpatrick Valley Forge & Welding HEN-ROB Torch Dealer.  Teaching The Fundamentals of Metal Shaping www.jerekirkpatrick.com All tools are a hammer except the chisel.....That's a screwdriver.
|
 |
|
|
Linear Mode
