|
|
|
#1
08-22-2015, 01:57 AM
|
|||
|
|||
New Bloke from Western Australia
Hello,I have been fabricating out of metal for many years but am keen to learn as much as possible on shifting sheet metal around and forming panels.
I have built a couple of cars and made a few replacement panels,I have a few tools but am hungry to learn the correct use of them to get the best out of them and myself. Chris
__________________
Life is not a practice run. 
|
|
#2
08-22-2015, 01:14 PM
|
|||
|
|||
|
Hi Chris welcome to the forum
Peter
__________________
P.Tommasini Metalshaping tools and dvds www.handbuilt.net.au Metalshaping clip on youtube http://www.youtube.com/watch?v=WEAh91hodPg Making Monaro Quarter panel: http://www.youtube.com/watch?v=KIpOhz0uGRM
|
|
#5
08-23-2015, 10:43 PM
|
||||
|
||||
|
Hello Chris and welcome to the site.
Jere
__________________
Jere Kirkpatrick Valley Forge & Welding HEN-ROB Torch Dealer.  Teaching The Fundamentals of Metal Shaping www.jerekirkpatrick.com All tools are a hammer except the chisel.....That's a screwdriver.
|
|
#6
08-24-2015, 05:28 PM
|
||||
|
||||
|
Great knowledge on this site so you can learn a lot.
__________________
Marcus aka. Gojeep Victoria, Australia http://willyshotrod.com Invention is a combination of brains and materials. The more brains you use, the less materials you need.
|
 |
|
|
Linear Mode
