|
|
|
#1
08-19-2015, 11:20 PM
|
|||
|
|||
Greetings from the Sunshine Coast Australia
Hi Folks, What a great site and a wealth of old and and new craft knowledge .
I'm starting a jaguar ss100 type build using a 1927 Chevy chassis which will need to be tweaked in a few places, an xj6 will be donating it's running gear. I think this forum is going to be a big help. 
|
|
#2
08-20-2015, 07:16 AM
|
||||
|
||||
|
Nialls
Welcome to Allmetalshaping. Sounds like a great project, look forward to seeing the progress. Steve
__________________
Steve Hamilton Hamilton Classics Auto Restoration & Metalshaping
|
|
#3
08-20-2015, 10:18 AM
|
||||
|
||||
|
Hello Niallsand welcome to the forum.
How about some photos of the Jag. Jere
__________________
Jere Kirkpatrick Valley Forge & Welding HEN-ROB Torch Dealer.  Teaching The Fundamentals of Metal Shaping www.jerekirkpatrick.com All tools are a hammer except the chisel.....That's a screwdriver.
|
|
#4
08-20-2015, 05:34 PM
|
|||
|
|||
|
Hi Nialls welcome to the forum
Peter
__________________
P.Tommasini Metalshaping tools and dvds www.handbuilt.net.au Metalshaping clip on youtube http://www.youtube.com/watch?v=WEAh91hodPg Making Monaro Quarter panel: http://www.youtube.com/watch?v=KIpOhz0uGRM
|
|
#5
08-20-2015, 07:45 PM
|
|||
|
|||
|
Thanks for the welcome folks
I will post photo's when the project really gets under way collecting parts, planing and the rules and regulations department ! have taken there time . Plenty to learn here along the way. Niall
__________________
Niall Richardson
|
 |
|
|
Linear Mode
