|
|
|
|
|
#1
06-24-2012, 11:23 PM
|
|||
|
|||
New Canadian
Hi all, my name is Greg and I found this site through a coversation with Dan Pate (Hope that is your correct name) at Back to the 50's this weekend. I used to be a regular on the metal meet site, but in the last few years I have not been doing much metal shaping. I used to do a lot of restoration/custom work at my shop but in the past few years we have been mainly doing collision repairs as that seems to pay better these days. I am about to start on a project of my own again ( a 1950 Chev pickup) and hope to put some of my shaping tools to use soon. I am a much better fabricator than a metal shaper and look forward to learning from you all. After looking through the site, I see many familiar names from the other site.
__________________
Greg 
|
|
#2
06-24-2012, 11:30 PM
|
||||
|
||||
|
Greg, welcome and thanks for the introduction. Hope you enjoy the site and find it helpful. Thanks for joining us.
__________________
Joe Hartson There is more than one way to go to town and they are all correct.
|
|
#4
06-25-2012, 07:19 AM
|
||||
|
||||
|
Hi Greg, Good to hear from you again. Welcome to AllMetalShaping.
__________________
Kerry Pinkerton
|
|
#6
06-25-2012, 11:33 AM
|
||||
|
||||
|
Not yet Greg. Here is the build thread. http://allmetalshaping.com/showthrea...highlight=deco
__________________
Kerry Pinkerton
|
|
#7
07-04-2012, 10:43 PM
|
|||
|
|||
|
HI Greg welcome to the forum
Peter
__________________
P.Tommasini Metalshaping tools and dvds www.handbuilt.net.au Metalshaping clip on youtube http://www.youtube.com/watch?v=WEAh91hodPg Making Monaro Quarter panel: http://www.youtube.com/watch?v=KIpOhz0uGRM
|
 |
|
|
Hybrid Mode
