New Canadian
 

Hi all, my name is Greg and I found this site through a coversation with Dan Pate (Hope that is your correct name) at Back to the 50's this weekend. I used to be a regular on the metal meet site, but in the last few years I have not been doing much metal shaping. I used to do a lot of restoration/custom work at my shop but in the past few years we have been mainly doing collision repairs as that seems to pay better these days. I am about to start on a project of my own again ( a 1950 Chev pickup) and hope to put some of my shaping tools to use soon. I am a much better fabricator than a metal shaper and look forward to learning from you all. After looking through the site, I see many familiar names from the other site.

Greg, welcome and thanks for the introduction. Hope you enjoy the site and find it helpful. Thanks for joining us.

Hi Greg and welcome!:D

Hi Greg, Good to hear from you again. Welcome to AllMetalShaping.

Thanks for welcomes. Hi Kerry, did you ever finish the roadster you were working on? Are there any pics of it on this site? Greg

Not yet Greg. Here is the build thread. http://allmetalshaping.com/showthrea...highlight=deco

Hi Greg! Welcome to the forum from Niagara Falls, Ontario :):) You'll find a great gang here.

Cheers!

Hello Gregand welcome to allmetalshaping!.

David

Welcome, from another newbie and a fellow Canadian.

hi Greg, nice to see another manitoban on board!