![]() |
|
#101
|
|||
|
|||
![]() Quote:
Well done Jaroslav.
__________________
In the morning I was convinced that this was the only solution. Witold https://photos.app.goo.gl/VTz6ETWQhnKyqUQYA https://www.youtube.com/watch?v=hzcKlFjOAoE http://forum.poziome.pl/index.php?topic=1989.0 |
#102
|
|||
|
|||
![]()
Witold, good progress. When I see that spider... that web...
![]() I was finishing the templates for my car with the customer I was saying "how bad you approved it, I do will shape it". Agreed so far. Only I must had to take a break.
__________________
Jaroslav |
#103
|
|||
|
|||
![]()
__________________
In the morning I was convinced that this was the only solution. Witold https://photos.app.goo.gl/VTz6ETWQhnKyqUQYA https://www.youtube.com/watch?v=hzcKlFjOAoE http://forum.poziome.pl/index.php?topic=1989.0 |
#104
|
|||
|
|||
![]()
Everyone tells me I'm doing it wrong. I am shaping the fender from only two parts. Yes, it takes more work and thinking. But it is possible. Maybe next time I will make smaller pieces. I don't know.
![]()
__________________
Jaroslav |
#105
|
|||
|
|||
![]()
The lower part has a rather sharp angle. For now, an attempt at molding from one piece. The stress is transmitted in all directions. I haven't messed it up yet.
![]()
__________________
Jaroslav |
#106
|
|||
|
|||
![]()
Some progress today. I finished the bottom part.
We gradually cut the sheet to the thickness of the disk. Then they gradually welded. Still I must finish shaping and wire to the edge. ![]()
__________________
Jaroslav |
#107
|
|||
|
|||
![]()
Very nice job!
__________________
Jan |
#108
|
|||
|
|||
![]() Quote:
__________________
Pat |
#109
|
|||
|
|||
![]()
Thank you Pat. I struggled a bit with the second fender. I couldn't align and adapt it to the template. I pushed the wave from both sides, but it worked. I ended up using heat. Now it will be easier to arrange end the shape. Both fenders hold their shape.
After cutting through both parts, the excess strip will remain on both sides.
__________________
Jaroslav Last edited by Jaroslav; 09-19-2022 at 04:25 AM. |
#110
|
|||
|
|||
![]()
Nice progress, really love how it is taking shape!
Antoine
__________________
Antoine Puygranier Resurrecting a 60 ghia: http://www.allmetalshaping.com/showthread.php?t=18852 Fixing a 914: https://allmetalshaping.com/showthread.php?t=20624 |
![]() |
Thread Tools | Search this Thread |
Display Modes | |
|
|