|
|
|
#1
08-03-2021, 01:48 AM
|
|||
|
|||
Found my way here when I should be working
Hi folks, another Aussie here, Rodney from Melbourne.
Short version..I ended up here chasing info/clues about thumbnail dies. Longer version... I'm a qualified panel beater, now working for myself doing all things rust and custom metal related in a small shop in South eastern Melbourne. Long term customer has me working on his LH Torana sedan involving quite a bit of subtle custom mods to suit a big hp motor combo. I make just about everything myself including my own power hammer that is almost complete. Mostly looking for ideas and ways to fit tools and other stuff. Couple of videos of my hammer if you are interested. Thanks. Test run on 1.0 mm cold rolled steel https://youtu.be/v7mTrD0pxF0 Overview of the build on my hammer from junk https://youtu.be/swU3DxbUwew
__________________
Rodney, Melbourne Australia https://www.facebook.com/rjlowtherpanelworks 
|
|
#2
08-03-2021, 09:00 AM
|
||||
|
||||
|
Hi Rodney
Welcome to Allmetalshaping! Steve
__________________
Steve Hamilton Hamilton Classics Auto Restoration & Metalshaping
|
|
#3
08-03-2021, 09:30 PM
|
|||
|
|||
|
Thanks Steve 👍
__________________
Rodney, Melbourne Australia https://www.facebook.com/rjlowtherpanelworks
|
|
#4
08-08-2021, 04:06 AM
|
||||
|
||||
|
Welcome to the forum mate.
__________________
Marcus aka. Gojeep Victoria, Australia http://willyshotrod.com Invention is a combination of brains and materials. The more brains you use, the less materials you need.
|
 |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Linear Mode
