All MetalShaping

Go Back   All MetalShaping > GETTING STARTED > Introductions
  Today's Posts Posts for Last 7 Days Posts for Last 14 Days  

Reply
 
Thread Tools Search this Thread Display Modes
  #1  
Old 12-07-2023, 02:32 PM
stueeee stueeee is offline
Member
 
Join Date: Dec 2023
Location: North West Kent, UK
Posts: 4
Default Newby from NW Kent UK

Hi to all, I'm a retired engineer these days and have been messing with old cars and motorbikes since I was a young teen. These days I have a well equipped workshop and enough ongoing projects to last till I'm about 120 years old. The particular reason for wanting to join this forum is that one of my projects -a 1930s single seat racer needs a new tail to be made in Aluminium. I have an English wheel here but at the moment, not the skill to make the best use of it, I am determined to change that, although it is likely that I will turn a lot of perfectly good ali sheet into scrap metal first.

Stuart
Reply With Quote
  #2  
Old 12-08-2023, 07:46 AM
dwmh dwmh is offline
MetalShaper of the Month May 2018, July 2022
 
Join Date: Aug 2015
Location: Nr Oxford UK
Posts: 666
Default

Welcome to the forum Stuart. You should find all the help you need here.
__________________
David Hamer
Reply With Quote
  #3  
Old 12-08-2023, 08:08 AM
Marc Bourget Marc Bourget is offline
Member
 
Join Date: May 2013
Location: North Ca
Posts: 725
Default

Welcome,


Keep in mind, you also turned a lot of perfectly good paper into scrap learning to write. That and the current quest should not be considered a waste of either time or materials if responsibly approached!!
__________________
Marc
Reply With Quote
  #4  
Old 12-08-2023, 08:14 AM
Mike Whelan Mike Whelan is offline
Member
 
Join Date: May 2016
Location: Germany
Posts: 28
Default

Hi Stuart,

I'm also a retired engineer (i'm 78 years old).Several years ago I built a small English wheel (22 inch throat). I watched a lot of videos and read a lot but in the end I decided that personal tuition was needed. I went to several courses in the UK and found Geoff Moss (ex Aston Martin) very good. He is located in Devon.

Mike (nr Trier, Germany)
__________________
Mike Whelan
Reply With Quote
  #5  
Old 12-08-2023, 08:53 AM
Jaroslav Jaroslav is offline
MetalShaper of the Month April 2020, September 2021, November 2022
 
Join Date: Dec 2012
Location: Czech Republic
Posts: 2,612
Default

Stuart, don't take your pants down when the ford is still far away...
Make several smaller trial pieces. Try to work so that the sheet is always soft. A paper template will help a lot. It will show you where to lengthen the fibers and where to shorten them. Show your project and get lots of advice. You can then choose the path that will be good for you.
__________________
Jaroslav
Reply With Quote
Reply

Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

All times are GMT -5. The time now is 11:37 AM.

Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.