#1
|
|||
|
|||
Howdy from Texas!
I've wanted to learn more about mastering metal for decades, and finally have the time now in our new empty nest. With our son away at college, I look forward to learning from the countless experts in this forum. I've been a hot rodder since birth and still own a 1934 Ford Tudor Sedan which my dad bought two years before I was born. Together, we've logged well over 300,000 miles on four rebuilds since the mid 60's and hopefully our boy will put a couple hundred thousand more miles on it after I give up the keys...but that may be a few more years!
We just built a new shop behind our new empty nest out in the country. I finally have a place worthy of metal shaping and room for the tools of the trade. I have the typical TIG, MIG, Mill, Lathe, Bandsaws, chassis table, etc. and look forward to adding a planishing hammer and possible E-wheel. I enjoy the old cars & trucks, spending time in the shop and shooting sporting clays with friends. Thanks in advance for sharing your expertise with someone eager to learn how to do it the right way.
__________________
Best regards, Troy I'm always willing to learn...thanks for the lesson! |
#2
|
||||
|
||||
Hi Troy
Welcome to Allmetalshaping! Your full membership has been approved. There is a lot of content on the forum, enjoy the journey Steve
__________________
Steve Hamilton Hamilton Classics Auto Restoration & Metalshaping |
#3
|
|||
|
|||
Welcome to the forum, Troy.
__________________
AC Button II http://CarolinaSculptureStudio.com https://www.youtube.com/channel/UCzSYaYdis55gE-vqifzjA6A Carolina Sculpture Studio Channel |
|
|