|
|
|
#1
10-11-2012, 03:00 PM
|
|||
|
|||
<-------From The U.K.
Hello Metal Shapers, found this site today and decided to try and join. My names Tom and I have recently awakened a desire for all things metal. My father was a keen and well known steam engine model maker and left behind a very comprehensive workshop. I have started cleaning up and cataloging all his tools for the purpose of producing my own bike frame and various tools. I am literally champing at the bit to start
|
|
#2
10-11-2012, 06:25 PM
|
||||
|
||||
|
Tom, welcome and thanks for the introduction. Hope you enjoy the site and find it helpful. Thanks for joining us.
__________________
Joe Hartson There is more than one way to go to town and they are all correct.
|
|
#4
10-11-2012, 11:11 PM
|
|||
|
|||
|
HI Tom welcome to the forum
Peter
__________________
P.Tommasini Metalshaping tools and dvds www.handbuilt.net.au Metalshaping clip on youtube http://www.youtube.com/watch?v=WEAh91hodPg Making Monaro Quarter panel: http://www.youtube.com/watch?v=KIpOhz0uGRM
|
 |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Linear Mode
