#61
|
|||
|
|||
Impressive work, Martin!
|
#62
|
|||
|
|||
When can you swing by my shop for an afternoon or two to lend a hand? I'll buy some beer...
Seriously- Great looking parts and work. For the prior slam panel (with male & female forms), how did you employ the forms- in a hydraulic press or ??
__________________
AC Button II http://CarolinaSculptureStudio.com https://www.youtube.com/channel/UCzSYaYdis55gE-vqifzjA6A Carolina Sculpture Studio Channel |
#63
|
|||
|
|||
Quote:
How did I press the shapes in?, have another guess , no hydraulics involved btw Dan, you can't answer this as I mentioned on my IS page
__________________
Cheers Martin No matter how clever you think you are, stupidity is always one step ahead!!!! Last edited by Maxakarudy; 10-24-2018 at 08:31 AM. |
#64
|
||||
|
||||
Press sandwich in the English wheel?
Beautiful results!
__________________
Robert Instagram @ mccartney_paint_and_custom McCartney Paint and Custom YouTube channel |
#65
|
|||
|
|||
Thanks Robert,
On the right track, but not quite there
__________________
Cheers Martin No matter how clever you think you are, stupidity is always one step ahead!!!! |
#66
|
|||
|
|||
Big hammer i reckon to put them in. do you have the top rails where wing mounts to make there good fun i hate chopping lump out of rear wing to get to kidney bowls,You made nice job on leg.
__________________
Carl |
#67
|
|||
|
|||
Quote:
Maybe using them alternately as hammerforms- old fashion hammer & corking, flow forming, etc- then finishing the form by clamping the two together would be the preferred answer. I've got that level of technology here. No matter the method or answer, the beer offer remains on the table.
__________________
AC Button II http://CarolinaSculptureStudio.com https://www.youtube.com/channel/UCzSYaYdis55gE-vqifzjA6A Carolina Sculpture Studio Channel |
#68
|
||||
|
||||
Martin
I bet you put it out in the street and waited for a big truck to come by and run it over!!!! Well maybe not! Steve
__________________
Steve Hamilton Hamilton Classics Auto Restoration & Metalshaping |
#69
|
|||
|
|||
Thanks Carl,
The kidney bowls, sills, torque mounts & wing rails are really good, even the heater tubes!!, however there are lots of smallish rust holes everywhere they shouldn't be, so it's the proverbial swings & roundabouts scenario Steve, like Robert you are on the right lines, no hammers, no presses
__________________
Cheers Martin No matter how clever you think you are, stupidity is always one step ahead!!!! Last edited by Maxakarudy; 10-25-2018 at 01:03 AM. |
#70
|
|||
|
|||
I think the boards and blanks were screwed together, then run through a set of rollers several times
Chris
__________________
Chris Woolley |
Thread Tools | Search this Thread |
Display Modes | |
|
|