#1
|
|||
|
|||
Paying Customer in Calif. for Large Fender Job
This is a Heads-Up for you pro's in California.(Not my post)
A paying customer request on a thread titled "California Metal Shaping" at the HAMB: Quote: http://www.jalopyjournal.com/forum/s...20#post6813620 8/1/2011 #39 Paul123 FNG Join Date: Dec 2009 Location: Sacramento, CA Posts: 9 Re: California Metal Shaping? I was told Ca Metal Shaping were the people to handle a job I am working on, but they are now out of business. I need some '36 Auburn pontoon fenders made in sheet-metal. Does anybody know of a real good sheet-metal guy who can do compound curves, etc. These fenders are enormous - 102" long by 26". The are tear dropped shaped. Thanks, Paul You need to contact him by PM on the HAMB. If you are not registered there, you should be. Lots of good info and contacts to be had there.
__________________
Tom |
#2
|
|||
|
|||
If any of you guys would like to follow up on this lead, the EMail address for Paul is:
pdcllc@hotmail.com
__________________
Tom |
Thread Tools | Search this Thread |
Display Modes | |
|
|