|
|
|
#1
12-12-2012, 07:03 PM
|
|||
|
|||
Intro from WA
Not sure what happened to my first intro, but here goes again. I'm Josh from Camas, WA - not too far from Portland, OR. I was linked to AMS from another forum and after a few minutes of reading one thread I was hooked and realized I needed to join. I've done minimal shaping in the past (dishing stumps), but don't have any wheel or bag experience. Only tools I have that could be considered metal shaping are the hammers and anvil I have from a previous venture into bladesmithing. I've always wanted an eWheel and am hoping to find the knowledge and motivation to finally buy or build one from everyone here.
Cheers, Josh
__________________
Josh 
|
|
#3
12-12-2012, 07:21 PM
|
|||
|
|||
|
HI Josh
Welcome to the forum Peter
__________________
P.Tommasini Metalshaping tools and dvds www.handbuilt.net.au Metalshaping clip on youtube http://www.youtube.com/watch?v=WEAh91hodPg Making Monaro Quarter panel: http://www.youtube.com/watch?v=KIpOhz0uGRM
|
 |
|
|
Linear Mode
