|
|
|
#1
05-20-2016, 11:23 AM
|
|||
|
|||
new member intro
Hi,
I found this site recently and am interested in learning more about automotive metal shaping/fabrication. As a hobby I've restored a couple cars, most recently a '67 Mustang convertible. Although I am ok at welding and basic bodywork, I'd like to be able to form my own patch panels for those times when repro/replacement stuff isn't available, as well as be able to customize/fabricate other panels and trim in my hobby. Looking forward to learning more...
__________________
-Chris 
|
|
#2
05-21-2016, 11:54 AM
|
||||
|
||||
|
Hello Chris and welcome to the site.
Jere
__________________
Jere Kirkpatrick Valley Forge & Welding HEN-ROB Torch Dealer.  Teaching The Fundamentals of Metal Shaping www.jerekirkpatrick.com All tools are a hammer except the chisel.....That's a screwdriver.
|
|
#3
05-22-2016, 07:26 AM
|
|||
|
|||
|
Hi Chris welcome to the forum
Peter
__________________
P.Tommasini Metalshaping tools and dvds www.handbuilt.net.au Metalshaping clip on youtube http://www.youtube.com/watch?v=WEAh91hodPg Making Monaro Quarter panel: http://www.youtube.com/watch?v=KIpOhz0uGRM
|
 |
|
|
Linear Mode
