Intro from WA

[myamoto1]

Not sure what happened to my first intro, but here goes again. I'm Josh from Camas, WA - not too far from Portland, OR. I was linked to AMS from another forum and after a few minutes of reading one thread I was hooked and realized I needed to join. I've done minimal shaping in the past (dishing stumps), but don't have any wheel or bag experience. Only tools I have that could be considered metal shaping are the hammers and anvil I have from a previous venture into bladesmithing. I've always wanted an eWheel and am hoping to find the knowledge and motivation to finally buy or build one from everyone here.

Cheers,

Josh