|
|
|
#1
02-15-2011, 09:51 PM
|
|||
|
|||
Intro
Hi. My name is Mike and I reside in Australia.
Ive owned a variety of cars, most post 1990s. However, I have recently purchased a 1965 Ford Falcon that is it need of minor rust repair. Ive read various forums over the years on metal shaping and took a welding course about 2 years ago, but thats as far as my knowledge and experience goes (complete novice). Prior to the Falcon I owned a 2002 Toyota Hilux (minitruck) that I paid a panel beater to build for me. Here are a few photos. Before:  After:   The Falcon-  So ive got the car, Ive got the drive (and shed) to do it myself this time, I need to buy the tools and of course further my limited knowledge.
__________________
Mike | www.methodphotography.com Vehicle | 1965 Ford Falcon XP Deluxe Sedan 
|
|
#3
02-17-2011, 10:02 PM
|
||||
|
||||
|
Welcome Mike!!!
Your going to have fun here! Mark D
|
|
#4
02-18-2011, 10:06 AM
|
||||
|
||||
|
Mike, welcome and thanks for the introduction. Lots of information to get you started on the site. Thanks for joining us. Hope to see some pictures as you start on the Falcon.
__________________
Joe Hartson There is more than one way to go to town and they are all correct.
|
|
#6
02-18-2011, 04:42 PM
|
|||
|
|||
|
Hi Mike Welcome to the site, there is always something worth reading on here.
David
__________________
Metalshaping DVD. www.metalshapingzone.com Metalshaping with hand tools on youtube http://www.youtube.com/watch?v=IGElSHzm0q8 All things are possible.
|
 |
|
|
Linear Mode
