|
|
|
|
|
#1
02-24-2012, 11:50 PM
|
|||
|
|||
New guy from Ms
Hello, my name is Brad. I'm retired and just finished building a 1931 Ford hot rod. I learned quite a bit during the build about metal working, but the main lesson was the realization of how much I don't know. I was/am an aircraft mechanic and did quite a bit of sheetmetal work back in the day, which basically included panel replacement, some panel fabrication and riveting. I am familiar with some metal working tools such as sheet metal brakes, shears and the basic handtools. I recently acquired a cheapo Woodward Fab bead roller and rolled some door panels for the 31 coupe. They turned out OK for a newbee but the tool marks on the panel just prove to me that I need a lot of education on HOW to use the bead roller properly. I am very excited about following some threads and learning what I can. Once I get up the nerve, I may post something. Anyway, I'm here to learn and appreciate all the help I can get.
Brad 
|
|
#2
02-24-2012, 11:57 PM
|
||||
|
||||
|
Brad, welcome and thanks for the introduction. Hope you find the site helpful and enjoyable. Where are you located in Mississippi, I'm in Pass Christian. Thanks for joining us.
__________________
Joe Hartson There is more than one way to go to town and they are all correct.
|
|
#4
02-25-2012, 12:01 AM
|
||||
|
||||
|
If you get down to the coast let me know and I'll give you a shop tour. Hopefully it will be clean by then.
__________________
Joe Hartson There is more than one way to go to town and they are all correct.
|
 |
|
|
Hybrid Mode
