|
|
|
#1
12-30-2012, 10:22 PM
|
|||
|
|||
New member from Ga.
Hello my name is Doug, I am a new member. I decided to join so that I would have a place to ask questions about sheet metals tools and where to find parts for them. I have a few benders that I am needing parts for. I do not have the specs available right now. I will post them later. I did see a couple of folks discussing a Hercules pipe bender. That is what grabbed my attention. I have one and I need dies for it.
I am an experienced aluminum and steel tig welder. I weld mostly thin sheet metal. I have made everything from fan shrouds and dash boards to radius coping and facia. I think the craziest thing I have made so far was an aluminum fish tank to transport fish to the farmers market. Thats who I am and what I do. Thanks for reading.
__________________
Doug 
|
|
#2
12-30-2012, 10:39 PM
|
|||
|
|||
|
HI Doug welcome to the forum
Peter
__________________
P.Tommasini Metalshaping tools and dvds www.handbuilt.net.au Metalshaping clip on youtube http://www.youtube.com/watch?v=WEAh91hodPg Making Monaro Quarter panel: http://www.youtube.com/watch?v=KIpOhz0uGRM
|
|
#3
12-30-2012, 10:45 PM
|
|||
|
|||
|
Thanks
Thank you,
I think I will enjoy this. I have seen a lot of interesting things already.
__________________
Doug
|
 |
|
|
Linear Mode
