|
|
|
#1
04-12-2012, 02:21 PM
|
|||
|
|||
New member from BC Canada
My name is Brian and to paraphrase another sig I saw once, I have been making sheet metal into scrap one project at a time for 40 years. I started with Ron Fournier's book "Metal Fabricators Handbook". I was building off road dune buggies and was expecting lots of chassis work with tube bending etc. I was initially disapointed to find it was mostly panel beating but the more I read, the more fascinated I got. Most of my practice has been simple body work but I keep dreaming about a big project. Most of my metal work is still bending, welding, and turning but sooner or later I will get to more panel beating. I also dabble in woodworking and electronics.
Brian Howden 
|
|
#2
04-12-2012, 02:30 PM
|
||||
|
||||
|
Brian, welcome and thanks for the introduction. Glad that you were able to get registered and become a member. Hope you find the site helpful and enjoyable. Thanks for joining us.
__________________
Joe Hartson There is more than one way to go to town and they are all correct.
|
|
#3
04-12-2012, 05:16 PM
|
|||
|
|||
|
HI and welcome Brian
Peter
__________________
P.Tommasini Metalshaping tools and dvds www.handbuilt.net.au Metalshaping clip on youtube http://www.youtube.com/watch?v=WEAh91hodPg Making Monaro Quarter panel: http://www.youtube.com/watch?v=KIpOhz0uGRM
|
|
#4
04-13-2012, 05:02 PM
|
|||
|
|||
|
Hello Brian, welcome to allmetalshaping!.
David
__________________
Metalshaping DVD. www.metalshapingzone.com Metalshaping with hand tools on youtube http://www.youtube.com/watch?v=IGElSHzm0q8 All things are possible.
|
 |
|
|
Linear Mode
