|
|
|
#1
04-06-2012, 10:36 AM
|
|||
|
|||
New member from Sweden.
Hi! I´m Mats from sweden. I´m here looking for tips on how to use pullmax machines.
I have had a p2 for many years but never really understood its capabilitys. I´m looking forward to read what you do with these machines in the us since they are so rarely used here.
__________________
Mats 
|
|
#2
04-06-2012, 01:36 PM
|
||||
|
||||
|
Mats, welcome and thanks for the introduction. Hope you find the site helpful and enjoyable. Ask questions if you have them about the Pullmax. Thanks for joining us.
__________________
Joe Hartson There is more than one way to go to town and they are all correct.
|
|
#3
04-06-2012, 05:50 PM
|
|||
|
|||
|
HI Mats and welcome to the forum, there is a book out by Fay Buttler that will show you all you need to know about pullmax
Peter
__________________
P.Tommasini Metalshaping tools and dvds www.handbuilt.net.au Metalshaping clip on youtube http://www.youtube.com/watch?v=WEAh91hodPg Making Monaro Quarter panel: http://www.youtube.com/watch?v=KIpOhz0uGRM
|
|
#4
04-06-2012, 10:41 PM
|
||||
|
||||
|
Hi and welcome Mats,
 If you do a search on "pullmax" you should have enough to read for a week  Here I did one for you. http://allmetalshaping.com/search.php?searchid=797323 Have fun reading
__________________
Rick Scott The second mouse gets the cheese!
|
|
#5
04-07-2012, 01:53 AM
|
|||
|
|||
|
Hi and welcome Mats
Pullmax is one of the most useful machines for a really low cost Sure you will find all you need to know and maybe even more on this site about metalshaping....
|
 |
|
|
Linear Mode
