|
|
|
#1
02-14-2012, 12:23 AM
|
|||
|
|||
Introduction from Long Beach
My name is Nate. I'm doing some work for my daughter who is disabled. A lot of the items that we bought for her when she was young are getting too small and braking. I'm currently working on a 'bouncy' seat for her. The one that she had been using has broken many times. I had it welded at the local muffler shop a couple times, but the stress points weren't holding up with her weight. So I'm here to ask some questions about bending some spring metal to act as the 'bouncy' part for her chair. Thanks for any help here.
Nate
__________________
Nate Dawson 
|
|
#2
02-14-2012, 12:31 AM
|
||||
|
||||
|
Nate, welcome to the site. Our main focus on this site is shaping sheet metal by shrinking or stretching the metal. Maybe someone here can help you with your question. Thanks for joining us.
__________________
Joe Hartson There is more than one way to go to town and they are all correct.
|
|
#4
02-14-2012, 04:32 AM
|
|||
|
|||
|
Welcome to the site Nate
Peter
__________________
P.Tommasini Metalshaping tools and dvds www.handbuilt.net.au Metalshaping clip on youtube http://www.youtube.com/watch?v=WEAh91hodPg Making Monaro Quarter panel: http://www.youtube.com/watch?v=KIpOhz0uGRM
|
 |
|
|
Linear Mode
