|
|
|
#1
01-14-2011, 12:59 AM
|
|||
|
|||
Hi from NZ
Hi all. I'm a metal spinner from down here in New Zealand.
I popped in here for a bit of a nosey as i'm taking on a new project that is completely different for me and I need some inspiration/guidance. I'm used to doing all my metal shaping on a lathe so now when it comes to making curved panels i'm a newbie!! I'm currently building a volksrod. Custom 4x2 chassis, beetle front end and vw type 3 rear subframe/engine. It is a 4 seater roadster pickup and as much as it will be a fun vehicle it will also be a rolling billboard covered in spun items. So anyway as well as getting educated on a bit of shaping i'll also hang round the metal spinning threads a bit and help out where possible and maybe even show a few items. 
Last edited by Kerry Pinkerton; 01-14-2011 at 01:04 AM. Reason: PMed for name 
|
|
#2
01-14-2011, 08:23 AM
|
||||
|
||||
|
Fred, welcome to the site. Thanks for the introduction. We have several metal spinners as members. Thanks for joining us.
__________________
Joe Hartson There is more than one way to go to town and they are all correct.
|
 |
|
|
Linear Mode
