|
|
|
#1
08-20-2017, 03:22 PM
|
|||
|
|||
Introduction from newbie in Portugal
Hi,
I'm Ricardo from Lisbon area, Portugal. I have started to learn several metal techniques, from simple soldering to casting and most recently shaping. I don't have a particular goal in mind, but hope to pick up some projects as I progress along. So far my limited knowledge comes from some youtube videos I found, and I'm looking for a bit more interaction. Best regards to all,
__________________
Ricardo Ferreira 
|
|
#2
08-21-2017, 01:02 PM
|
|||
|
|||
|
Welcome Ricardo! There is a lot of good information on this site. Check out the following youtube video by Wray Schelin. It's a good one with a lot of valuable information.
https://www.youtube.com/watch?v=xeXtezrmK3M -Chris
__________________
Chris
|
|
#3
08-21-2017, 06:38 PM
|
|||
|
|||
|
Hi Ricardo welcome to the forum
Peter
__________________
P.Tommasini Metalshaping tools and dvds www.handbuilt.net.au Metalshaping clip on youtube http://www.youtube.com/watch?v=WEAh91hodPg Making Monaro Quarter panel: http://www.youtube.com/watch?v=KIpOhz0uGRM
|
 |
|
|
Linear Mode
