|
|
|
#1
03-14-2016, 04:37 AM
|
|||
|
|||
New Old Timer from WI
I'm Jim from Necedah, WI. Retired Machinist from City of Milwaukee. Did a lot of Industrial sheet metal (Cabinet type stuff) for Milwaukee as well repaired all construction equipment and boom trucks, as well as normal machinist work for Bureau of Electrical Services on Canal street. Been doing my own auto repairs since age of 16 and all home repairs(roofing, plumbing, heating, masonry. Just got a roll beader and learning the nuts & bolts.
|
|
#2
03-14-2016, 07:11 AM
|
|||
|
|||
|
Hi Jim welcome to the forum
Peter
__________________
P.Tommasini Metalshaping tools and dvds www.handbuilt.net.au Metalshaping clip on youtube http://www.youtube.com/watch?v=WEAh91hodPg Making Monaro Quarter panel: http://www.youtube.com/watch?v=KIpOhz0uGRM
|
|
#3
03-14-2016, 08:08 AM
|
||||
|
||||
|
Hi Jim
Welcome to the site. Good to see another WI member Steve
__________________
Steve Hamilton Hamilton Classics Auto Restoration & Metalshaping
|
|
#4
03-14-2016, 11:05 AM
|
||||
|
||||
|
Hello Jim and welcome to the site.
If you have a mill and a lathe at home this site will keep you humming for a long time.    Jere
__________________
Jere Kirkpatrick Valley Forge & Welding HEN-ROB Torch Dealer.  Teaching The Fundamentals of Metal Shaping www.jerekirkpatrick.com All tools are a hammer except the chisel.....That's a screwdriver.
|
 |
|
|
Linear Mode
