|
|
|
#1
05-06-2014, 07:24 AM
|
|||
|
|||
Hi from WA
a bit about myself. the WA is Western Australia (Perth) which is swiftly being dug up and sent to china. I have two cars on the go at the moment, a 71 Valiant Coupe similar to the dodge dart of the same era. this was going to be a quick tidy up and then drive(haha), but I keep going "while the weheels are off I will just do this and then that", so taking time. the other is a 48 Plymouth 4 door which is getting a Jag front and rear and a 360 v8. this will be a long term project!
lots of body work to be done and this is the reason I have joined the site. presently house sitting and the cars are at my house so I don't get there much so slow going at the moment.  Tony 
|
|
#3
05-06-2014, 10:08 AM
|
||||
|
||||
|
Hello Tony and welcome to the site.
Jere
__________________
Jere Kirkpatrick Valley Forge & Welding HEN-ROB Torch Dealer.  Teaching The Fundamentals of Metal Shaping www.jerekirkpatrick.com All tools are a hammer except the chisel.....That's a screwdriver.
|
|
#4
05-06-2014, 02:36 PM
|
|||
|
|||
|
Hi Tony welcome to the forum
Peter
__________________
P.Tommasini Metalshaping tools and dvds www.handbuilt.net.au Metalshaping clip on youtube http://www.youtube.com/watch?v=WEAh91hodPg Making Monaro Quarter panel: http://www.youtube.com/watch?v=KIpOhz0uGRM
|
|
#5
05-06-2014, 06:19 PM
|
|||
|
|||
|
hello tony ,welcome to the site
__________________
Clive ross
|
|
#6
05-10-2014, 07:26 AM
|
|||
|
|||
|
Hey mate, welcome, I'm in pinjarra and have a 69 val hardtop project.
__________________
Charlie Charlie Chop Customs Western Australia
|
|
#7
05-10-2014, 09:58 AM
|
|||
|
|||
|
Welcome to the forum Tony.
David
__________________
Metalshaping DVD. www.metalshapingzone.com Metalshaping with hand tools on youtube http://www.youtube.com/watch?v=IGElSHzm0q8 All things are possible.
|
 |
|
|
Linear Mode
