|
|
|
#1
03-30-2014, 02:40 PM
|
||||
|
||||
Hello everyone!!!
Hey everyone. My name is Matt and I work on classic cars and motorcycles in Austin, TX. I'm looking forward to learning as much as I can about advanced sheet metal shaping. Thanks to the admins for setting up this site.
__________________
Matt B. The early bird gets the worm but the early worm gets eaten 
|
|
#3
03-30-2014, 09:15 PM
|
|||
|
|||
|
Hi Matt welcome to the forum
Peter
__________________
P.Tommasini Metalshaping tools and dvds www.handbuilt.net.au Metalshaping clip on youtube http://www.youtube.com/watch?v=WEAh91hodPg Making Monaro Quarter panel: http://www.youtube.com/watch?v=KIpOhz0uGRM
|
|
#4
03-31-2014, 12:42 PM
|
||||
|
||||
|
Welcome to the site Matt.
Jere
__________________
Jere Kirkpatrick Valley Forge & Welding HEN-ROB Torch Dealer.  Teaching The Fundamentals of Metal Shaping www.jerekirkpatrick.com All tools are a hammer except the chisel.....That's a screwdriver.
|
 |
|
|
Linear Mode
