|
|
|
#1
01-04-2014, 08:59 PM
|
|||
|
|||
new member from manitoba
my name is Bernard Rempel,found your site while looking for panel beater bags, and read about turning a purse into a beater bag . Great idea! I would like to join and learn more tips and tricks.
__________________
Bernard Rempel 
|
|
#3
01-05-2014, 06:15 AM
|
|||
|
|||
|
Hi Bernard welcome to the forum
Peter
__________________
P.Tommasini Metalshaping tools and dvds www.handbuilt.net.au Metalshaping clip on youtube http://www.youtube.com/watch?v=WEAh91hodPg Making Monaro Quarter panel: http://www.youtube.com/watch?v=KIpOhz0uGRM
|
|
#4
01-05-2014, 11:39 AM
|
|||
|
|||
|
Hi Bernard. Welcome to the forum.
You mentioned the purse to beater bag, you might have over-read the part where the purse failed and spread sand around in the shop. The way I read the purse as bag story "yes, it works -- for a while, keep looking for a real bag." You might make a single sided bag from a scrap leather chunk and nail it to a high quality plywood backer, lotsa nails around the edge. use it fully supported. This will work -- for a while. Again, welcome.
__________________
Doug
|
 |
|
|
Linear Mode
