|
|
|
#1
08-05-2015, 11:06 AM
|
|||
|
|||
New member from OK
My name's Leon, I have a fab shop that I run on my days off from the Fire Department. I mainly work on race cars but also do a lot of aluminum welding. I find a lot of good information on the internet and its always good to have another source.
|
|
#2
08-05-2015, 07:14 PM
|
|||
|
|||
|
Hi Leon welcome to the forum
Peter
__________________
P.Tommasini Metalshaping tools and dvds www.handbuilt.net.au Metalshaping clip on youtube http://www.youtube.com/watch?v=WEAh91hodPg Making Monaro Quarter panel: http://www.youtube.com/watch?v=KIpOhz0uGRM
|
|
#3
08-06-2015, 11:21 AM
|
||||
|
||||
|
Hello Leon and welcome.
Jere
__________________
Jere Kirkpatrick Valley Forge & Welding HEN-ROB Torch Dealer.  Teaching The Fundamentals of Metal Shaping www.jerekirkpatrick.com All tools are a hammer except the chisel.....That's a screwdriver.
|
 |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Linear Mode
