|
|
|
#1
10-24-2011, 04:26 PM
|
|||
|
|||
LI New York
Hello,
Bought an old sportster awhile ago which led to me buying a bolt on hard tail which led me to me buying a welder and hard tailing it which led me to buying a pipe bender and bending bars which led me to want to make gas tanks and fenders which well brought me here! Oh, there is also the, “had to buy a lathe” to make my own bungs which meant I had to learn how to cut my own tooling and well, I’ll leave that story for a different website. I have been struggling a bit with tuck shrinking metal with a set of forks I made and hope to get a glimpse of how it’s done so I can make a one off sportster tank that doesn't look like it was used as a hack-e-sack. I’m a HVAC/R commercial tech with a mechanical troubleshooting back ground. Danny 
|
|
#2
10-24-2011, 09:00 PM
|
||||
|
||||
|
Danny, welcome and thanks for the introduction. You have a good start on getting tools, just realize it never ends. Thanks for joining us.
__________________
Joe Hartson There is more than one way to go to town and they are all correct.
|
|
#4
10-25-2011, 11:54 AM
|
|||
|
|||
|
Hello Danny, welcome to the site.
David
__________________
Metalshaping DVD. www.metalshapingzone.com Metalshaping with hand tools on youtube http://www.youtube.com/watch?v=IGElSHzm0q8 All things are possible.
|
 |
|
|
Linear Mode
