|
|
|
#1
02-01-2015, 08:11 AM
|
|||
|
|||
Hey Everyone
Hi guys new to the page and relatively new to the world of sheet metal fab. I am currently rebuilding a 1935 Chevy pickup. For those who don't know the cab is constructed out of an ash frame with sheet metal panels nailed to it. I chopped 3" out of the top and here begins my struggle. I have a fair amount of shaping tools I built over the years and haven't used a whole lot. The english wheel is the main one. I have been watching videos on line about tips and tricks. Figured a good forum like this would be another great resource.
Jeff
__________________
Jeff - Attempting to hammer my way through a 1935 Chevy Pickup. 
|
|
#2
02-01-2015, 06:07 PM
|
|||
|
|||
|
Hi Jeff welcome to the forum
Peter
__________________
P.Tommasini Metalshaping tools and dvds www.handbuilt.net.au Metalshaping clip on youtube http://www.youtube.com/watch?v=WEAh91hodPg Making Monaro Quarter panel: http://www.youtube.com/watch?v=KIpOhz0uGRM
|
 |
|
|
Linear Mode
