|
|
|
#1
06-22-2014, 05:52 PM
|
|||
|
|||
vintage cr 750 gas tank
Hello ladies and gents,
James here from tucson, I joined this community to share my adventures in restoring vintage metal working machines and motorcycles and to learn more about shaping and welding aluminum and titanium. I have reams of it and need to make something of it. My immediate goal is to fabricate a honda cr 750 race bike gas tank as the men who are building these are getting older than me and retiring for good. Need to carry on the legacy before it dies. Thanks James
__________________
james fredrickson 
|
|
#2
06-22-2014, 09:09 PM
|
||||
|
||||
|
Hello James and welcome to the site.
Jere
__________________
Jere Kirkpatrick Valley Forge & Welding HEN-ROB Torch Dealer.  Teaching The Fundamentals of Metal Shaping www.jerekirkpatrick.com All tools are a hammer except the chisel.....That's a screwdriver.
|
|
#4
06-23-2014, 01:37 PM
|
||||
|
||||
|
Hi James, have you checked out the Hand Built motorcycle show? It's fairly close to you. I didn't hear about it until it was over or I would have gone.
http://www.handbuiltmotorcycleshow.com/ I'm hoping to go next year if it's still going on.
__________________
http://pokiespages.com/
|
|
#5
06-23-2014, 02:28 PM
|
|||
|
|||
|
Welcome to allmetalshaping James.
David
__________________
Metalshaping DVD. www.metalshapingzone.com Metalshaping with hand tools on youtube http://www.youtube.com/watch?v=IGElSHzm0q8 All things are possible.
|
 |
|
|
Linear Mode
