|
|
|
#1
01-24-2012, 08:46 PM
|
|||
|
|||
Hello from Northern Ontario!
Just thought i would make my introduction. I'm a machinist living near Sudbury. I'm hoping to learn a little about metalshaping from this site so i can replace the hundred or so pounds of bondo on my 86 Dodge with some sheetmetal!
__________________
Andy N 
|
|
#2
01-24-2012, 11:28 PM
|
||||
|
||||
|
Andy, welcome and thanks for the introduction. Hope you find the site helpful and enjoyable. Thanks for joining us.
__________________
Joe Hartson There is more than one way to go to town and they are all correct.
|
|
#3
01-25-2012, 12:47 AM
|
|||
|
|||
|
Welcome to the site Andy
Peter
__________________
P.Tommasini Metalshaping tools and dvds www.handbuilt.net.au Metalshaping clip on youtube http://www.youtube.com/watch?v=WEAh91hodPg Making Monaro Quarter panel: http://www.youtube.com/watch?v=KIpOhz0uGRM
|
 |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Linear Mode
