View Single Post
  #15  
Old 05-05-2021, 03:51 PM
Jaroslav Jaroslav is offline
MetalShaper of the Month April 2020, September 2021, November 2022
 
Join Date: Dec 2012
Location: Czech Republic
Posts: 2,601
Default

Bart. Bend the edges of the sheet metal upside down. The edge will hold its shape. After shape you straighten the shape or cut it. You can better control the shape you make. Not now. It's alive in all directions.
Or you can fasten the angle with clamps or weld points.
DSC097081.jpg
__________________
Jaroslav
Reply With Quote