So, that was the next logical step..primer on the passenger side fender (and all around the windshield after taking it also to bare metal) :
And I took care of a few holes on the driver's side firewall:
For the bottom part, I will wait to have the body on the cart/body frame as not only the bottom of the firewall but also the floor is affected. More on that later :wink:
Before starting the body frame /hell hole fix, I wanted to check how the quarter is (part of me knowing I might have to cut it to repair right the right long).. Here the result, quite impressive..
So now I know it.. I will build from scratch that quarter panel and cut it, repair the long, weld my new panel.
Just for fun I made a small test panel to try the shape of the wheel opening:
But I hadn't a large enough sheet metal piece to start on the quarter panel so I starte on my body frame..
Fresh metal came:
Welded the long part:
Rest will follow with all the fixations I planned (bumpers, engine, gearbox, front axle, back axle,..) to keep the body square du ring welding.
Stay tuned !
Antoine