View Single Post
  #1  
Old 09-23-2021, 04:26 AM
Louis_C Louis_C is offline
Member
 
Join Date: Sep 2021
Location: Essex - UK
Posts: 2
Default Door pocket repair

Good morning all,

This is my first post on the forum, hopefully this is the best place for the thread! I am very new to sheet metal work at this level and am more of an enthusiastic amateur.

I am trying to repair a pair of doors, but the pockets are in a bad way. Repair panels are not available, neither are replacements so looking at options really so am looking for advice. My main concern is the complex curvature of the panel.

All 4 corners are in need of repair so I likely will replace the whole units. I do not need perfection as it will not be entering any events, I just want to avoid rust issues later! I planned to re-use the top bracing section, and then make the main body, and later weld on two end pieces but would appreciate any tips/advice before getting started.



Thank you
__________________
Louis
Reply With Quote